Re: Danke für den Tip

[ Zauberspiegel Wissenschaft Ideenfabrik ]

Geschrieben von anonym am 06. Januar 2003 00:35:32:

Als Antwort auf: Danke für den Tip geschrieben von Tiger am 05. Juni 2001 18:23:55:

>leider nützt er mir nicht viel, weil ich mich auf die andere Coler-Maschine, den Stromerzeuger, konzentriere (Der hier beschriebene Magnetstromapparat ist schon mehrfach nachgebaut worden und wird übereinstimmend als sehr schwach und unzuverlässig beschrieben.). Auch dafür gibt es Beschreibungen und eine prinzipielle Bauanleitung, die sich allesamt auf den B.I.O.S.-Report gründen (britischer Geheimdienst), den ich mir irgendwo im Internet herunter geladen habe (weiß nicht mehr, wo); er wurde in den 50er Jahren veröffentlicht, und alles, was sonst über die Coler-Maschinen zu finden ist, gründet sich praktisch ausschließlich auf diesen einen Bericht. Leider ist die veröffentlichte Version aber ganz offensichtlich gekürzt, denn während einerseits detaillierte Messreihen aufgelistet sind, wobei die verwendeten Messgeräte mit Typ und Seriennummer genannt werden, fehlen zu den Bauteilen des Stromerzeugers jegliche konkreten Daten. Weiß vielleicht sonst noch jemand etwas darüber?
>Gruß von Tiger

Im Internet wird man kaum etwas neues über Coler´s Magnetstromaparat finden.
Aber ein einfaches Experiment über einen Physikalischen Effekt habe ich auf
einer Ungarischen Homepage gefunden (in Englisch) vieleicht bringt´s was.
Habe noch keine Zeit gehabt es zu Überprüfen.
Hier nun der Originaltext:


Magnetical Electron Driver

A method to convert magnetism directly into electricity, without using moving parts.

by Dipl. Ing. Volker Hennig created July 20th, 1999

Here it is, my report about a thing that must have been unnoticed by the pioneers of electromagnetism, because it needs just two components and it´s terribly simple ...
Please imagine a standard DC electromagnet: Electrical current is running around a magnetical bar and causes magnetical poles at the ends of that bar.
Now, I asked myself:
If a magnetical current (means flux) runs around an electrical bar, will it cause electrical poles (voltage) at the ends of this bar ?
And as I have checked, the answer is : YES !
There are two ways to produce such a magnetical coil :
1) A very long and thin permanent magnet (like a wire, with the poles at its ends) is wrapped around a stick or a rod. The sum of magnetic field-lines inside it mainly represents a tube of ´rotating flux´. (Like the current in an electrical coil represents a tube of rotating current, but, the electrical coil must be driven by voltage, the magnetical coil already has its inner magnetical voltage!)
2) A high electric current, sent through a conducting rod, creates the proper, non-polar magnetic field to magnetize a tube, made of good permanent-magnetic material, which is placed around the rod. The same kind of ´rotating flux´ as above should exist in that tube. But not exactly the same... (See comment 1 later)

My experiment : I took the magnetic tape out of one audio cassette (metal type, which is pre-magnetized in longitudinal direction) and wrapped it around an aluminium rod (length: 1 m, round diameter: 8 mm), which was clamped in a drilling machine for that purpose. The tape was wrapped back and forth, making several layers, and leaving some free space at the rod´s ends. (The intention is, to imitate the kind of magnetic field, that appears with electric current. The amount of flux in such a field depends on the length of the conductor and the distance to it. Therefore a long and thin conductor is advantageous. A thinner rod would have been better.)
Even this "poor" arrangement was successful: I could measure a DC voltage between the ends of the rod, even though its resistance is almost zero ohms. (And even though the audio tape consists of about 85% plastic carrier material and only a few (< 5) gramms of magnetic material !)
Actually I expected to find this system self-amplifying, because the generated current has the right direction to produce a magnetic field, that amplifies the generating field.
But unfortunately, it behaves like a self-charging capacitor : Each time, the voltmeter is connected, the voltage goes down like a capacitor discharging curve (from about 50 mV to 10 mV in about 1 minute). It seems, somehow the magnetic field collapses (slowly), but obviously it is not destroyed, ´cause it can recover very fast. That means: to get energy out of this system, the tapping must be pulsed.
I have not yet found a logically really satisfying explanation for this behavior, but I can say this :
Comment 1:
There should be a difference between a magnetical coil, that can be seen as one very long, wrapped field-line, and a magnetical tube, which can be seen as a lot of circle field-lines. A coil with its two ends (poles) is an open system, and a tube is a closed system, it has no poles and no end (in this context).
Another difference is between an electrical voltage source, that uses its outside current to drive a load, and this magnetical voltage source, which uses its inside flux to drive something, let´s say : itself, because magnetical voltage consists of ALIGNMENT of many elementary magnetic units, and so the material is magnetical voltage itself. The ring-flux inside a tube-system at least should amplify its own alignment. (Please imagine a DC electromagnet, where the coil is replaced by a copper tube. This tube would not have an inner electrical voltage. (But, if it would be possible to make a current flow around inside it, the thing would work well as an electromagnet.))
And, in my experiment a very weak magnetic voltage source was applied.
So, these reasons make me think : A magnetical TUBE-system may supply a CONSTANT DC VOLTAGE (or even be self-amplifying...) !

Please feel free to investigate it deeper.

Some concluding sentences :
Generally, NON-POLAR MAGNETISM is the key word here.
And : whenever one face of electromagnetism is flowing straight along and the other face is turning around it, VORTEX STRUCTURES must be involved, that make one of the faces BIPOLAR .
I don´t know, wether or not the magnetic energy will be consumed with time. If yes, did I invent a magnetic battery ? If no, perhaps mass will be consumed ? Or aether ?
However, I´m sure it was no antenna phenomenon.
Probably it would be too much, if I claimed to be the inventor of " MAGNETO-ELECTRISM " ?
But I do claim to be the first one, who thought about using permanent magnets, that are shaped as a coil or a tube ( or a spiral as well ).
Further, I predict, that also pure mechanical, magnetical
motors can be built very easily with such kinds of magnets. I have some ideas already ...
The here described tube- or coil- type system I would like to call " MAGNETICAL ELECTRON DRIVER (MED) ".

If you know (or are) a person or company, which can produce a strong, non-polar, permanent tube-magnet, please contact me.
So far, Best wishes and success for other experiments,

Volker Hennig


Die Ungarische Hompage URL weiß ich nicht mehr,ich gebe Dir eine andere.
( http://www.rexresearch.com/index.htm )

Ich kann auch nicht besonders gut Englisch, vieleicht kannst Du eine Übersetzung ins Netz stellen ?

Gruß ....... ?


Antworten:

[ Zauberspiegel Wissenschaft Ideenfabrik ]